Madas EVQ-1 Manual Del Usuario página 20

5.2 - REPLACING THE COIL
I) Fastening nut
Loosen the brake kit (19) with a
strap-type wrench for oil filters
m
Now proceed with replacing the coil
p
Remove the washer (II)
s
• On completion of the above operations, proceed with wiring the coil just installed, as shown in 3.2
EV(Q-R-S-T)-1-3-6
II) Washer
n
Loosen the nut (I) with a 35mm
q
Insert the new coil and washer and
t
III) Threaded bar
Remove the washer (18)
commercial spanner
tighten the brake kit
20
Madas Technical Manual - 1|1.5d - REV. 1 of 10
Complete coil
(including connector/board)
supplied as a spare part
Extract and remove the coil (4)
o
Remove the coil from the threaded
bar (III)
r
Using a strap-type wrench for oil
filters, tighten the brake kit (19)
u
Sep 2020
th