Cequent Performance Products 24958 Instrucciones De Instalación página 10

5. Fascia removal - use plastic trim tools to remove the fascia starting at the outer edges near the wheel wells and gently pull the
fascia. Disconnect wiring harness on passenger side if present, see Figure 5. Carefully set the fascia aside for reinstallation.
6. Bumper beam/Sensor removal – (a) use 15 mm socket to remove (8) factory flange nuts from bumper beam and another (8)
nd
factory flange nuts from the bumper end panel. NOTE: Some models might have 2 layer of bumper beam inside. If it is present,
remove it and return to vehicle owner. (b) use 8 mm socket to remove the sensor located in the center of bumper end panel.
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 10 of 36 24958NP 04-04-17 Rev. A