Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. Front bottom appearance panel removal - use 10 mm socket to remove (3) screws from front end of front bottom appearance panel and (6) screws from intersection line
between front and rear bottom appearance panel. Detach the front bottom appearance panel. Use 10 socket to remove (3) flange nuts from the studs on trunk pan and (2) screws
from chrome piece. Use T30 torxbit socket to remove (2) screws from rear bottom appearance panel. Pull the rear bottom appearance panel downward and loosen it from studs.
Front bottom panel
Rear bottom panel
(3) stud
locations
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico
Sheet 7 of 36
24958NP
04-04-17
Rev. A
Publicidad
Tabla de contenido
