Troubleshooting - GYS GYSFLASH 30.12 PL Manual Del Usuario

1
Step : Analysis
Analyses the battery state (charge level, polarity inversion, wrong battery...)
2
Step : Recovery (
Recovering damaged elements due to a prolonged deep discharge.
3
Step : Charge (
- 7 A /
Maximum current fast charge to reach 90% charge level.
4
Step : Absorption (13.8 V)
Constant voltage charge to reach 98% charge level.
• Estimated charge time :
Charging current
Battery capacity 15 Ah 60 Ah 60 Ah 100 Ah 100 Ah 220 Ah
Charge timing
0% >>> 90% 2 h
• Protections :
The GYSFLASH 30.12 PL has comprehensive safety features to protect it against short-circuits and polarity reversals.
It has an anti-spark feature which prevents sparks whilst connecting the device to the battery. This charger has
double insulation and is safe to use with the battery in situ as it will protect the vehicle's on-board electronics.
The GYSFLASH 30.12 PL is fitted with an integrated temperature sensor that ensures that the charging current is adapted to the
ambient temperature to prevent internal the electronics from overheating.

TROUBLESHOOTING

Troubleshooting
1
The indicator flashed.
2
The indicator is on.
Indicator stays on even after pressing
3
button.
4
Indicator flashes.
5
Indicator stays on.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
GYSFLASH 30.12 PL
- 0.5 A / - 1 A /
- 15 A /
Lead-acid
8 h 4 h 6 h 3 h
• Polarity reversal
• Battery voltage is too high
• Clamps in short-circuit
• Charge failure, battery cannot be
recovered
• Ambient temperature is too low to
charge a LFP battery
Thermal protection
Charger in sleep mode
Charge interrupted by pressing
Step
Charge conservation test.
Step
- 2 A)
Reduce current charge to reach 100% charge
level.
Step
- 30 A)
Balancing of battery cells.
Step
Maintains battery charge level at its maximum
and goes through charge maintenance cycle
every 10 days.
375 Ah 7 Ah 15 Ah 15 Ah 30 Ah 30 Ah 220 Ah 375 Ah
7 h 12 h 1h
Causes
• Check that the clamps are connected correctly
• Check that battery is 12 V
• Change the battery and press
restart a charge.
• Charge the battery at milder temperature or press
the
Ambient temperature is too high (>50°C), cool the
room and let the charger cool down.
Press button
the charger to exit sleep mode.
Press
.
5
: Test
6
: Supplement
7
: Equalizing / balancing (14.4 V)
8
: Floating charge (13.8 V)
Lithium
2h 1h 2h 1h
Solutions
button.
or connect a battery to
again to restart the charge.
UK
7h 12h
to
11