ENGLISH
USES
Grade 2 and 3 Ankle Sprains, Stable Fractures, Post-Operative
Use, Trauma, Rehabilitation, and Hot/Cold Therapy
CAUTION
DO NOT REMOVE WALKER UNLESS INSTRUCTED BY
PHYSICIAN.
1. This product has been designed and tested based on single
patient usage and is not recommended for multiple patient
usage.
2. If skin irritations of any kind develop, consult medical
professional immediately.
3. Be sure the patient performs circulation checks. If a loss of
circulation is felt, or if the walker feels too tight, release contact
closure straps and adjust to a comfortable level. If discomfort
continues, the patient should contact their medical professional
immediately.
4. Caution should be used if prescribed for patients with
diabetes, vascular deficiencies, and neuropathies.
5. Do not remove the inner foam pads which are adhered to the
plastic walker boot.
PHOTO CAPTIONS
A. Pull tab
B. Walker struts
C. Softgood
D. Rocker bottom base
E. Adjustable contact closure straps
F. Foam pads
FITTING INSTRUCTIONS
1. Remove softgood by opening contact closure straps and
lifting out of brace. Do not remove pull tabs at this time.
2. Place lower leg and foot into softgood. Close softgood snugly
over leg.
3. Insert foot into brace by gently spreading uprights. Do not
remove pull tabs at this time.
4. Ensure struts are centered over the ankle bone (malleoli). The
lower leg should be kept at a 90° angle with the foot.
5. Remove pull tabs located in between struts and softgood. This
allows the softgood to be secured into position.
6. To accommodate for rubbing or spacing, additional foam
pads may be placed inside the softgood, between the softgood
and plastic, or under straps for additional comfort.
7. Secure contact closure straps, starting at the toes and working
upward. For best fit, secure straps in the correct order.
Strap adjustments may be necessary as foot, ankle and leg
swelling patterns change.
8. When prescribed by physician, remove leg from product by
releasing contact closure straps and opening softgood.
Pull foot and leg forward and out, leaving softgood inside
the brace. If softgood is removed, follow Steps 1 through 7 to
reapply.
WASHING INSTRUCTIONS
1. This product can be washed at any time by hand using a mild
detergent and cold water. Remove softgood from walker plastic
before washing. Do not use bleach or strong detergent. Do not
wash in washing machine or place in dryer. Air dry flat.
2. Walker plastic can be washed with a damp cloth and mild
soap.
5