Tightening Up - Truper SINA-10 Instructivo

Tighten up the rotating table to make miter cuts
• To make 45° and up to -45° miter cuts use the rotating
table (15).
• Press the miter bracing lock (18) to release the rotating
table. Turn the table without releasing the lock and using
the control knob (17).
• Turn the table into the desired angle. Use the miter scale
(16) as an aid. This scale is built with 0°, ±15°, ±22.5 °
±31,6° and ±45° stops to quickly set the most common
miter angles.
• Release the blocking lock to fix the table.
WARNING • Double-check the rotating table is
perfectly blocked before starting to cut. Otherwise the table
could move and cause a severe injury.
Tighten up the cutter head to make bevel cuts
• To make 0° and up to 45° bevel cuts tighten up the
cutter head column into the desired angle.
• For angles different to 0° loosen the bevel cut knob (26)
and turn the column into the desired angle using the bevel
cut scale (27) as guide.
• Tighten the bevel cut knob to block the column.
WARNING • Double-check to tighten the knob to
fix the column before starting to cut. Otherwise the cutter
head could move and cause severe injury.
35°
bevel cut
In the illustration the cut guide is
not shown to notice the bevel stops
10
ENGLISH
0°
bevel cut

Tightening Up

26
27
15
18 17
45° miter cut
16
0° miter cut
-45° miter cut