Putting Into Operation - Rothenberger ROWELD P 800 B Instrucciones De Uso

3.2 Operating instructions
In accordance with national or EU ordinances and guidelines, e. g. DVS 2212,
Section I, only duly qualified and authorised personnel are allowed to operate the
ROWELD welding machines.
Only trained and authorised welders are allowed to operate the machine!
3.2.1

Putting into operation

Please read through the operating instructions and safety instructions
attentively before you put the butt fusion welding machine into operation!
Do not use the heating element in explosive environments or bring it into
contact with easily flammable materials.
Stay a safe distance away from the machine. Do not stand or reach into the
machine. Keep other people away from the work area.
Before every start-up, check the oil level of the hydraulic unit. The oil level must
be between the min. and max. marking on dipstick in the oil filler cap. If
necessary, add HLP 46 hydraulic oil.
Transport and set the hydraulic unit only in a horizontal position. If it is set at an
angle, oil escapes from the vented plugs with the dipstick.
 Connect the hydraulic unit to the basic unit with both hydraulic hoses
Protect the quick couplings from contamination. Replace leaky couplings
immediately!
 Connect the mains plugs of control box modul to the power outlet/supply specified on the
type plates.
 Connect the trimmer unit, hydraulic unit and heating plate mains plugs to the control box
modul.
 Switch on the main switch of control box modul.
 Set required temperature (cf. temperature controller).
The rise in temperature is indicated by a red signal lamp on the temperature controller.
The display generally indicates the actual temperature value. In accordance with national
ordinances and guidelines, e. g. DVS, the heating plate is ready after maintaining the setpoint
temperature for at least 10 minutes. Verify heating plate temperature with a temperature
meter.
Risk of serious injury! The heating plate can reach temperatures of over 300°C
(575°F)! We highly recommend storing the heating plate in the designated
carrying frame immediately after use!
The welding machine is equipped with a Type 400 digital temperature controller.
The digital temperature controller has been ideally configured and set before leaving our factory.
To set temperature simply press the F key until "_SP" is indicated in the display. The operator
can now adjust the setpoint temperature between 0-300°C with the arrow keys.
18
All manuals and user guides at all-guides.com
Pressure relief valve, pull lowered the pressure.
Filler neck, cap with oil dip stic
ENGLISH