Basic Unit (A); Hydraulic Unit (B); Operating Instructions; Putting Into Operation - Rothenberger ROWELD P 800 B Instrucciones De Uso

3.1.1 Basic unit
1 Movable clamps
2 Sliding clamps
3.1.2 Hydraulic unit
1 filler neck and dip stick
2 fast-on connector
3 relief valve
4
fast-on coupling sleeve
The hydraulic unit allows the operator to operate the welding machine and perform the functions
indicated by the following symbols:
To close the clamps press the control lever
To open the clamps pull the control lever
Pressure adjusting valve for milling pressure, beat forming pressure, heating
pressure and cooling pressure. The manometer provides information on the
regulated pressure
Pressure relief valve, pull lowered the pressure
3.2

Operating instructions

In accordance with national or EU ordinances and guidelines, e. g. DVS 2212, Section I,
only duly qualified and authorised personnel are allowed to operate the ROWELD weld-
ing machines!
Only trained and authorised welders are allowed to operate the machine!
3.2.1

Putting into operation

Please read through the operating instructions and safety instructions attentively before
you put the butt fusion welding machine into operation!
Do not use the heating element in explosive environments or bring it into contact with
easily flammable materials!
Stay a safe distance away from the machine. Do not stand or reach into the machine.
Keep other people away from the work area!
Before every start-up, check the oil level of the hydraulic unit. The oil level must be
between the min. and max. marking on dipstick in the oil filler cap. If necessary, add
HLP 46 hydraulic oil!
Transport and set the hydraulic unit only in a horizontal position. If it is set at an angle,
oil escapes from the vented plugs with the dipstick!
 Connect the hydraulic unit to the basic unit with both hydraulic hoses.
Protect the quick couplings from contamination. Replace leaky couplings immediately!
 Connect the mains plugs of control box modul to the power outlet/supply specified on the
type plates
 Connect the trimmer unit, hydraulic unit and heating plate mains plugs to the control box
modul.
 Switch on the main switch of control box modul.
16
3 Spacer with locking notch
4 Heating element take-off device
5 manometer
6 control lever press = close
control lever pull = open
7 pressure adjustment valve
ENGLISH
(A)
(B)