Assembly Preparation; Assembly Instructions; Mounting The Wheels To The Legs - Pit Boss PB700T1 Montaje Y Operación

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack
after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before
assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to
assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Service for parts: Monday
through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.

1. MOUNTING THE WHEELS TO THE LEGS

Parts Required:
2 x Leg with Wheel Axle (#16)
2 x Wheel (#19)
2 x Nut (#D)
2 x Washer (#E)
Installation:
• Slide a wheel onto each leg with wheel axle. Secure using a washer and
nut. Spin each wheel to ensure the wheels turn freely.

ASSEMBLY PREPARATION

IMPORTANT: To ease installation, using two people is helpful
(but not necessary) when assembling this unit.

ASSEMBLY INSTRUCTIONS

1
16
19
E
D
7