Festo BAW−HSW−10 Manual Del Usuario página 20

To set the waiting position
1. Pressurise the swivel module of the HSW and, with a
delay, the actuating cylinder of the BAW−HSW.
2. Loosen the locking nut 1 of the shock absorber.
3. Turn the shock absorber (A) while at the same time
holding the lock nut in place until the desired position
is reached.
Note:
The shock absorber must project at least 1 mm, and
the lock nut must grip all threads.
4. Tighten the lock nut 1 (tightening torque è table in
the chapter Fitting Mounting on the handling
module").
20 Festo BAW−HSW−... 1009a English
(A)
1