Having A Problem? (Troubleshooting) - Chamberlain Whisper Drive Security+ Manual Del Propietário

Having a Problem? (Troubleshooting)

1. My door will not close and the light bulbs blink on
my motor unit: The safety reversing sensor must be
connected and aligned correctly before the garage door
opener will move in the down direction.
• Verify the safety reversing sensors are properly
installed, aligned and free of any obstructions.
Refer to Installation Step 11: Install The
Protector System
• Check diagnostic LED for fl ashes on the motor
unit then refer to the Diagnostic Chart on the
following page.
2. My remotes will not activate the door:
• Verify your Smart Control Panel
is blinking, deactivate the Lock Mode following the
instructions for Using the Wall-Mounted
Door Control.
• Reprogram remotes following the programming
instructions. Refer to Programming.
• If remote will still not activate your door, check
diagnostic LED for fl ashes on motor unit then refer
to Diagnostic Chart on the following page.
3. My door reverses for no apparent reason: Repeat
safety reverse test after adjustments to force or travel
limits. The need for occasional adjustment for the force
and limit settings is normal. Weather conditions in
particular can affect door travel.
• Manually check door for balance or any
binding problems.
• Refer to Adjustment Step 2, Set the Force.
4. My door reverses for no apparent reason after fully
closing and touching the fl oor: Repeat safety reverse
test after adjustments to force or travel limits. The
need for occasional adjustment for the force and limit
settings is normal. Weather conditions in particular can
affect door travel.
• Refer to Adjustment Step 1, Program the
Travel Limits.
5. My lights will not turn off when door is open:
• The garage door opener is equipped with a security
light feature. This feature activates the light on when
the safety sensor beam has been obstructed. Refer
to Operation section; Using the Wall-Mounted Door
Control, Light Feature.
6. My motor unit hums briefl y:
• First verify that the trolley is against the stop bolt.
• Release the door from the opener by pulling the
Emergency Release Rope.
• Manually bring the door to a closed position.
• Loosen the belt by adjusting the outer nut 4 to 5
turns. This relieves the tension.
® .
®
is not blinking. If it
Bell Wire
Safety Reversing Sensor
Sending Eye Safety
Reversing Sensor
(Amber Indicator Light)
• Run the motor unit from the remote control or door
control. The trolley should travel towards the door
and stop. If the trolley re-engages with the door,
pull the Emergency Release Rope to disengage.
Trolley
• Re-Tighten the outer nut until the trolley spring is
approximately 1-1/4" (3.18 cm) in length.
• If the trolley does not move away from the bolt,
repeat the steps above.
7. If battery status LED is not lit properly:
• Check battery connections.
8. My garage door opener beeps:
• A solid LED with beep, sounding approximately
every 2 seconds, indicates the motor unit is
activating the door and is operating off of
the battery.
• A fl ashing LED with beep, sounding every
30 seconds, indicates battery is low.
• If a red LED remains on when the power is restored,
and is accompanied by a beep sounding every
30 seconds, replace the battery.
34
Diagnostics
Located On
Motor Unit
"Learn"
Button
LED or
Diagnostic
LED
Receiving Eye Safety
Reversing Sensor
(Green Indicator Light)
1-1/4"
(3.18 cm)