Programming; To Erase All Codes From Motor Unit Memory; To Add Or Reprogram A Hand-Held Remote Control; Using The Door Control - Chamberlain Whisper Drive Security+ Manual Del Propietário

PROGRAMMING

NOTICE: If this Security ✚
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The
door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
remote* that you wish to operate
your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted
remote, fi rst erase all codes:
Press and hold the purple "learn"
button on motor unit until the
learn indicator light goes out
(approximately 6 seconds). All
previous codes are now erased. Reprogram each
remote or keyless entry you wish to use.
® garage door opener is operated with a non-rolling code transmitter, the technical measure

To Add or Reprogram a Hand-held Remote Control

USING THE DOOR CONTROL

1. Press the Prog <Learn> button
on the door control.
2. Press the Prog <Learn> button
again to confi rm Learn Mode.
3. Press the button on the
hand-held remote* that you wish
to operate your garage door.
4. When the motor unit lights blink,
it has learned the code. If light
bulbs are not installed, two clicks
will be heard.
*3-Button Remotes (315 MHz)
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
®
Security✚
3-Button remote
or compact remote
can be programmed
to operate other
®
Security✚ garage
door openers.
38
® 315 MHz remote controls.