Storing Breastmilk - Medela pump in style advanced Instrucciones

For Quicker Cleaning:
Medela offers Quick Clean Micro-Steam
™
disinfection. (Not recommended for use with SoftFit
Tubing Care:
Inspect tubing after each pumping session for condensation and/or milk.
It is not necessary to clean tubing after every use.
If condensation appears in tubing:
To eliminate condensation after you have completed pumping, continue
running the pump with the tubing(s) attached for another 1-2 minutes
or until dry.
If There Is An Overflow:
If milk accidentally gets into the tubings:
1. Turn off the pump and unplug from power source.
2. Remove and disassemble the tubing. Wash in soapy water, then
rinse in cold clear water.
3. Shake water droplets out and hang to air-dry. For faster drying,
attach tubings to pump and run pump 1-2 minutes or until dry, or
pour a small amount of isopropyl alcohol through the tubings to dry.
(Tubing can be cleaned using a Quick Clean Micro-Steam bag. Make
sure tubing is fully immersed in water inside of bag).
If milk accidentally gets behind the diaphragm cap:
1. Turn off the pump and unplug from power source.
2. Remove and disassemble the tubing.
3. Snap off the diaphragm cap using
thumb tab.
4. Be sure the yellow plug is not plugged
into any ports prior to cleaning. Wash the
diaphragm cap in soapy water, then rinse
in cold, clear water.
6
bags for daily kit
™
breastshields).
™
5. Use a damp (not wet) cloth to wipe the diaphragm and bag. Do not
immerse the motor unit or any of the bags in water.
6. When components are completely dry, reassemble breastpump
and kit.

Storing Breastmilk

Check with your hospital for specific storage instructions.
When freezing, do not fill containers more than 3/4 full to allow space
for expansion. Label containers with the date of pumping.
Reference: www.BreastmilkGuidelines.com
Important Note: If the temperature in the room, car or outdoors
exceeds 77 °F / 25 °C, chill milk immediately to preserve freshness.
7