Producing Hot Water - UFESA CE7238 cream Manual De Instrucciones

EN
Frothing milk / Making Cappuccino
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Prepare espresso first with according to the "MAKE ESPRESSO COFFEE" section.
Fill a jug with about 100 grams of milk for each cappuccino to be prepared. You are recommended to use
whole milk at refrigerator or room temperature (not hot!).
Note: it is recommended that the diameter of the jug is not less than 70±5mm, and bear in mind that the milk
increases in volume by 2 times, make sure the height of jug is enough.
Turn the control knob to the right (steam position). Make sure the steam knob is at the min position.
Wait until the heating light is at the on position.
Insert the frothing nozzle into the milk about two centimeters, froth milk in the way moving vessel round from
up to down.
Turn the steam knob (6) slowly counterclockwise. Steam will come out from the frothing nozzle (12).
Note: Never turn the steam knob rapidly, as the steam will accumulate rapidly in short time which may
increase the potential of the risk of spillage.
When the frothing operation is finished, turn the steam knob to the min position.
Note: Clean the frothing nozzle (12) with a wet sponge immediately after steam stops generating, but care
not to hurt!
Pour the frothed milk into the espresso prepared. Now the cappuccino is ready. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.
Press the "on/off" button (18) to switch the appliance off.
Note: we recommend to allow the coffee maker to cool down at least for 5 min before making coffee again.
Otherwise burnt odor may occur in your espresso coffee.

Producing hot water

With this function, you can pre-heat your coffee cup to ensure that the temperature of the coffee will not
decrease. So as to improve the coffee flavor.
Clean your coffee cup. After drinking coffee, you can directly make hot water with this coffee maker to clean
the cups. This makes it more simple and convenient to clean the cups.
Press the on/off button.
Make sure that the steam and the control button are respectively on the minimum and Off position.
The pilot light will be illuminated and wait until the heating pilot light change color.
Turn the steam knob slowly anti-clockwise and then turn the on/off control knob to the left (coffee position)
and hot water will flow out from the steam wand.
When the required quantity is reached, turn the control knob to the "OFF" position.
Press the "on/off" button to switch the appliance off.
Note: At first the hot water will scatter from the steam wand. May let the steam wand outlet close to the
coffee cup wall. Thus at this moment, you need to pay attention to the protection of hot water splash burns
skin.
Producing steam to heat liquids
Make sure that the control knob is at the "OFF" position.
Press the "on/off" button to switch the appliance on.
Wait until the heating light will change color.
Dip the wand into the liquid to be heated.
Turn the steam knob slowly counterclockwise. Steam will come out from the wand.
When the desired temperature is reached, turn the steam knob to the min position.
Press the "on/off" button to switch the appliance off.
16