Tabla de contenido
Publicidad
Step 10
Step
Fasten three METAL BRACKETS (4G) to the ENDS (A and B) and BRACE (E). Use three BLACK 9/16" LARGE
å
HEAD SCREWS (1S).
NOTE: Be sure the BRACKETS are even with the edges of the ENDS and BRACE.
å
Fasten the BASE (F) to the BRACE (E). Tighten two HIDDEN CAMS.
å
Then, fasten the BASE (F) to the ENDS (A and B) and BRACE (E). Use three BLACK 9/16" LARGE HEAD SCREWS (1S)
å
through the BRACKETS on the ENDS and BRACE and into the holes in the BASE.
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
Maximum
210 degrees
Minimum
190 degrees
Page 14
1S
B
Arrow
E
4G
420545
Curved edge
F
A
4G
4G
www.sauder.com/service
Publicidad
Tabla de contenido
