Publicidad
Step 4
Step
Diagram 1. Measure 3" from one end of the INTERLOCK TRACK (22G). Position the INTERLOCK TRACK as shown.
å
SAFETY STOP / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (22G) into the SAFETY STOP (29G).
å
Diagram 3. Rotate the INTERLOCK TRACK and apply force to engage the second edge into the SAFETY STOP.
å
Diagram 4. Repeat the SAFETY STOP / TRACK ATTACHMENT for the next SAFETY STOP while holding the previously
å
completed SAFETY STOP in its location hole.
Visually check that all INTERLOCK TRACK edges have been engaged into the SAFETY STOP as shown in diagram 3.
å
Then, remove the INTERLOCK TRACK assembly from the END.
Be sure the
interlock track
snaps into each
safety stop.
A
22G
2.
29G
Page 8
The interlock system is a safety feature
that prevents more than one drawer
from opening at the same time. Do not
use excessive force to open the drawers.
22G
29G
3.
420545
29G
4.
Edge without
HIDDEN CAMS
22G
1.
Tape Measure
www.sauder.com/service
Publicidad
