Publicidad
Step 11
Fasten the TOP (C) to the ENDS (A and B). Tighten four HIDDEN CAMS.
å
Fasten the TOP MOLDING (H) to the TOP (C). Use three BLACK 1-1/4"
å
FLAT HEAD SCREWS (7S).
NOTE: Do not overtighten the SCREWS into the TOP.
å
Using your hammer, gently tap four TACK GLIDES (12E) into the bottom
å
edges of the ENDS (A and B) and BASE (F).
NOTE: Be sure to tap the TACK GLIDES into the center of the BASE.
å
www.sauder.com/service
B
420545
7S
BLACK 1-1/4" FLAT HEAD SCREW
(3 used in this step)
Tap the TACK GLIDES into
the center of the BASE.
A
F
12E
Page 15
Publicidad
