Publicidad
Step 14
Flip the drawer over onto the LEFT DRAWER SIDE (D32).
å
Diagram 1. Insert the tabs on a DRAWER STOP (20G) into the slots in a EXTENSION SLIDE (40MC). You may need to
å
insert one tab fi rst, then the other.
Diagram 2. Visually check that the DRAWER STOP (20G) is seated in the EXTENSION SLIDE (40MC).
å
Diagram 3. If the DRAWER STOP is not seated, use your hammer to gently tap the SLIDE until the tabs are properly seated
å
in the slots.
Now, fasten this EXTENSION SLIDE (40MC) to the RIGHT DRAWER SIDE (D33). Use two GOLD 5/16" FLAT HEAD SCREWS (3S)
å
through holes #1 and #4 in the SLIDES and into the exact holes shown in the DRAWER SIDE.
Repeat Steps 13 and 14 for the other drawer.
å
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
2
.
Post
D33
20G
3
.
Page 18
Slot
1
.
20G
These tabs must
insert into the slots.
20G
Seated
420545
1
2
3
4
D33
D32
www.sauder.com/service
Open end
Publicidad
