Publicidad
Step 5
Step
Insert the INTERLOCK TRACK (22G) with SAFETY STOPS (29G) into the groove in the RIGHT END (A) exactly as shown.
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below.
å
Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (40MA) to each END (A and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S)
å
through holes #1 and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
å
of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
Open end
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
www.sauder.com/service
40MC
4
3
2
B
1
1
Finished edge
3S
22G
3
A
4
4
3
2
After fastening the RAILS to the ENDS, rest the INTERLOCK
TRACK assembly against the RAILS. There should be no
more than a 1/16" gap between all ACTUATORS and RAILS.
420545
40MA
Finished edge
1
2
2
3
4
29G
Open end
1
Page 9
Publicidad
