Installing The Led Light Kit And Glass Shade - Kichler Starkk Manual De Instrucciones

INSTALLING THE LED LIGHT KIT AND GLASS SHADE

Step 1. Loosen the three mounting screws on the inside of the 16W LED light kit/
switch housing. (Fig.16)
Step 2. While holding the switch housing under your ceiling fan, push the square
wire connectors together, one from the fan and one from the switch housing.
Step 3. Tuck the connections neatly into the light plate. Place the key holes on the
16W LED light kit/switch housing over the 2 screws previously loosened from the
light plate, turn the 16W LED light kit/switch housing until it locks in place at the
narrow section of the key holes. Secure by tightening all three screws. (Fig.16)
Step 4. Raise the glass shade against the 16W LED light kit/switch housing and turn
clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 16)
14 | KICHLER.COM
Square wire
connector
16W LED light kit/
switch housing
Glass shade
Fig. 16
Light plate
Screws