Installing The Led Light Kit And Glass Shade Assembly - Kichler GENTRY XL 85 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING THE LED LIGHT KIT
AND GLASS SHADE ASSEMBLY
NOTE: Before starting installation, disconnect the power by turning off
the circuit breaker or removing the fuse at fuse box.
Step 1. Loosen the three mounting screws on the inside of the LED light
kit. (Fig.17)
Step 2. While holding the LED light kit under the fan motor, make the
wire connections: (Fig. 17)
- White to white
- Black to black
Step 3. Tuck the connections neatly into the light plate. Place the key
holes on the LED light kit over the 2 screws previously loosened from
the light plate, turn the LED light kit until it locks in place at the narrow
section of the key holes. Secure by tightening all three screws. (Fig.17)
Step 4. Raise the glass shade against the light plate and Secure by
tightening all three screws. (Fig. 18)
Light plate
Wire connectors
LED light kit
Fig. 17
Glass shade
assembly
Fig. 18
85" GENTRY XL | 15
Screws
Screws

Publicidad

Tabla de contenido
loading

Tabla de contenido