Installing The Light Kit And Glass Shade - Kichler 56 Guardian Manual De Instrucciones

INSTALLING THE LIGHT KIT AND GLASS SHADE

CAUTION: To Reduce The Risk Of Electric Shock, Disconnect The Electrical
Supply Circuit To The Fan Before Installing Light Kit.
Step 1. Hold the LED light kit to light plate, then connect the 2 single pin
connectors from the light kit to the 2 single pin connectors from the motor
assembly. Connect the black wire to the black wire, and the white wire to white
wire. Attach the light kit to the light plate and securely tighten with three (3)
screws from the screw pack. (Fig. 22)
Step 2. Secure the glass shade to light plate by turning in a clockwise direction.
Turn the glass shade gradually until it snaps on to the light plate. DO NOT
OVER-TIGHTEN. (Fig. 23)
Light Kit
Fig. 22
Glass Shade
Fig. 23
56" Guardian | 15