Installing The Led Light Kit And Glass Shade - Kichler VASSAR Manual De Instrucciones

INSTALLING THE LED LIGHT KIT
AND GLASS SHADE
NOTE: Before starting installation, disconnect the power by turning
off the circuit breaker or removing the fuse at fuse box.
Step 1. Loosen the three mounting screws on the inside of the LED
light kit. (Fig.18)
Step 2. While holding the LED light kit under the fan motor, make the
wire connections: (Fig. 18)
- Red to white
- Black to black
NOTE: If you do not plan to install the LED light kit with your fan at
this time, don't make the wire connections. Raise the decorative
bottom cover against the LED light kit and turn clockwise until snug,
DO NOT OVERTIGHTEN. (Fig. 19)
Step 3. Tuck the connections neatly into the light plate. Place the
key holes on the LED light kit over the 2 screws previously
loosened from the light plate, turn the LED light kit until it locks in
place at the narrow section of the key holes. Secure by tightening
all three screws. (Fig.18)
Step 4. Raise the glass shade against the light kit and turn
clockwise until snug, DO NOT OVERTIGHTEN. (Fig. 18)
Wire connectors
Light plate
LED light kit
Screws
Fig. 18
Decorative
bottom cover
Glass shade
Fig. 19
52" VASSAR LED | 15
TM