SBP - Sensor Board Pulse
Voltage range of the
digital inputs
NOTE
NOTE
Example of
connecting encoder
signals with HTL
level unipolar
7-6
Voltage range LOW
Voltage range HIGH
Table 7-5
Voltage range of digital inputs
Input current at a rated value of 24 V for HIGH level:
Input current LOW
Table 7-6
Input current for HIGH level
Input current at a rated value of 24 V for LOW level:
Input current LOW
Table 7-7
Input current for LOW level
The inputs are non-floating. The rough pulse is smoothed with 0.7 ms,
and the fine pulse with approx. 200 ns.
The SBP board is designed as a PELV circuit (Protective Extra Low
Voltage). The earth of the SBP board is connected with the PE
conductor (earth) inside the device.
The encoder is provided with signals of track A+, B+ and an additional
zero pulse.
In order to avoid any interference radiation on the signals, you should
bypass terminals A-, B-, zero- and CTRL- and connect to the encoder
ground.
The screen of the encoder line must be connected to ground over a
wide area, both on the motor side and on the converter side.
X 4 0 0
6 0
6 1
6 2
6 3
6 4
6 5
6 6
6 7
X 4 0 1
6 8
6 9
7 0
7 1
7 2
7 3
7 4
7 5
P E / s h ie ld
Fig. 7-3
Connection of a pulse encoder with HTL level
Rated value
Min.
0 V
-0,6 V
24 V
13 V
Min.
Rated value
8 mA
10 mA
Min.
Rated value
≤ 2 mA
6SE7087-6NX84-0FF5
Option boards
SIMOVERT MASTERDRIVES
06.2005
Max.
3 V
33 V
Max.
12 mA
Max.
-
+
A +
B +
Z e ro +
P u ls e e n c o d e r
Siemens AG