Displays; Start-Up - Siemens CBP Manual Del Usuario

CBP/CBP2 – Communication Board PROFIBUS
2.5

Displays

NOTE
Operating display
Fault display
2.6

Start-up

NOTE
2-6
There are three LED displays on the front of the CBP optional board
which supply information on the current operating status. The following
LEDs are provided:
♦ CBP operating (red)
♦ Data transfer with basic unit (yellow)
♦ Useful data transfer via PROFIBUS (green)
♦ During normal operation, all three LEDs repeatedly light up at the
same time and for the same length of time (flashing)!
♦ If an LED is continuously on or off, this indicates an exceptional
condition (parameterization phase or fault)!
LED Status
Red Flashing
Yellow Flashing
Green Flashing
Table 2-4 Operating display of the CBP
LED Status
Red off/on
Yellow off/on
Green off/on
Table 2-5 CBP fault display
After installation of the CBP optional board has been completed, an
automatic self-test will be carried out when the basic unit
(converter/inverter) is powered-up.
Afterwards, the new board may have to be logged in on the basic unit
and provided with a bus address. Please refer to the documentation on
the basic unit for further details in this respect.
Please refer to the documentation for the respective basic unit
regarding instructions for parameterization using the quick procedure.
Diagnostic information
CBP operating; voltage supply on
Fault-free data exchange with the basic unit
Fault-free useful data transfer via the PROFIBUS
Diagnostic information
Voltage supply for CBP cut off; replace CBP or basic
unit
Data exchange with the basic unit is not possible;
replace CBP or basic unit
Transfer of useful data via PROFIBUS is not
possible; PROFIBUS cable not connected or is
defective
6SE7087-6NX84-0FF5
Option boards
06.2005
Siemens AG
SIMOVERT MASTERDRIVES