Monogram ZIP360NN Manual De Instrucciones página 17

Installation Instructions - Standard Installation
STEP 4 ANTI-TIP PROCEDURE (CONT)
• Using a level, draw a horizontal line on the wall at this
height.
• Locate at least 2 studs on the back wall. Mark these
points on the horizontal line.
• Place the bottom of the wall bracket with tabs on the
horizontal line. Align the center notch on the bracket
with the center line on the wall.
Line on Wall
Center
• The anti-tip wall bracket has a series of holes. Select 2
holes that match with the located studs. Make sure the
holes selected are on the center of the studs. Mark the
wall at these points.
• Mark an additional hole at each end of the bracket.
If one of the studs is closer to the end of the bracket,
mark an additional hole towards the center of the
bracket.
31-1000451 Rev. 0
Two Additional
Hole Locations at
Ends of Brackets
• Drill 1/2" (1.27 cm) holes into the wall board at the
locations marked for the toggles to be mounted (not the
stud markings).
• Drill 3/16" (0.47 cm) holes into wooden studs where
marked. If steel stud construction, drill 1/2" (1.27 cm)
holes into the studs where marked. You will use 2
toggles with the metal studs.
Install Wall Toggles:
The wall toggles and bolts can be ordered as Service Kit
#WR49X10193. Wall toggles are installed in the drywall
and metal studs for stability. Install the wall toggles as
follows:
• Drill 1/2" (1.27 cm) holes at the wall markings made in
the holes at the ends of the wall bracket.
• Hold the metal channel flat against the plastic straps
and slide the channel through the hole.
• Gently pull back at
the ends of the plastic
straps to make the
channel rest flush
behind the wall.
• Hold the ends of the straps in
one hand and slide the plastic
cap along the straps until the
flange of the cap is flush with the
wall.
• Place your thumb between the
plastic straps and bend up and
down to snap the straps off at
the wall.
17
Wall Bracket
Center
Line On Wall
Wall Studs
Plastic Straps
Metal Channel
Cap