Peligro De Descarga Eléctrica; Step 2 Install Water Line; Filtration System; Osmosis System Or Other Household - Monogram ZIP360NN Manual De Instrucciones

Installation Instructions - Standard Installation

STEP 2 INSTALL WATER LINE

WARNING
Connect to potable water supply only.
A cold water supply is required for automatic icemaker
operation. The water pressure must be between 40 and
120 psi (275-827 kilopascals).
WARNING
ELECTRIC SHOCK HAZARD
Attach tubing clamp using existing hole only. DO NOT drill
into the refrigerator.
AVERTISSEMENT
alimentation d'eau potable seulement. Une alimentation
d'eau froide est requise pour faire fonctionner
la machine à glaçons et le pichet à remplissage
automatique. La pression d'eau doit se situer entre 40
et 120 psi. (275 à 827 kPa).
AVERTISSEMENT
Fixez le collier de serrage dans le trou présent seulement.
NE PERCEZ PAS dans le réfrigérateur.
ADVERTENCIA
suministro de agua potable únicamente. Se requiere
un suministro de agua fría para el funcionamiento de la
máquina de hielos automática y de la jarra de llenado
automático. La presión del agua deberá estar entre 40
y 120 p.s.i. (275 – 827 kPa).
ADVERTENCIA
Adhiera la abrazadera de la tubería usando el agujero
existente únicamente. NO perfore el refrigerador.
• A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 p.s.i. (275-827 kPa).
• Route 1/4" OD copper or SmartConnect
tubing between house cold water line and the water
connection location.
• Tubing should be long enough to extend to the
front of the refrigerator. Allow enough tubing to
accommodate bend leading into the water line
connection.
31-1000451 Rev. 0
Raccordez l'appareil à une
RISQUE DE DÉCHARGE
ÉLECTRIQUE
Realice la conexión a un
PELIGRO DE DESCARGA
ELÉCTRICA
™ plastic
Floor
Waterline Tubing
STEP 2 INSTALL WATER LINE
(Cont.)
NOTE: The only Monogram-approved plastic tubing is
supplied in the SmartConnect
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
SmartConnect ™ Refrigerator Tubing Kits are available
in the following lengths:
2' (.6 m) - WX08X10002
15' (4.6 m) - WX08X1 0015
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the
line of water.
• Install a shut-off valve between the icemaker water
valve and cold water pipe in a basement or cabinet.
The shut-off valve should be located where it will be
easily accessible.
• Turn on the main water supply and flush debris.
Run about a quart of water through the tubing into a
bucket. Shut off water supply at the shut-off valve.
NOTE: Saddle type shut-off valves are included in
many water supply kits, but are not recommended for
this application.
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle
valves are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.
STEP 2A WATER LINE
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM OR OTHER
HOUSEHOLD FILTRATION SYSTEM
Skip this step when not using an RO System or
other household filtration system.
If the water supply to the refrigerator is from a
household filtration system, use the refrigerator's filter
bypass plug. Using the refrigerator's water filtration
cartridge with the RO filter can result in hollow ice
cubes.
Filter Bypass Plug
15
™ Refrigerator Tubing kits.
8' (2.4 m) - WX08X10006
25' (7.6 m) - WX08X10025