Conexión A Tierra Del Refrigerador; Step 1 Remove Packaging - Monogram ZIP360NN Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions- Stainless Steel Installation
CONEXIÓN A TIERRA DEL
REFRIGERADOR
ADVERTENCIA
Eléctrica
Si no se siguen estas instrucciones, se podrá producir la
muerte, incendios o descargas eléctricas.
El cable de corriente de este electrodoméstico cuenta con
un enchufe de 3 cables (conexión a tierra) que se conecta a
un tomacorriente de pared estándar de 3 cables (conexión
a tierra) para minimizar el riesgo de posibles descargas
eléctricas por parte del mismo.
Contrate a un electricista calificado para que controle el
tomacorriente y el circuito eléctrico, a fin de asegurar que el
enchufe esté correctamente conectado a tierra.
En caso de contar con un tomacorriente de pared de 2
cables, es su responsabilidad y obligación reemplazarlo
por un tomacorriente de pared de 3 cables correctamente
conectado a tierra.
NUNCA, BAJO NINGUNA CIRCUNSTANCIA,
CORTE NI ELIMINE EL TERCER CABLE
(TIERRA) DEL CABLE DE CORRIENTE.
NO USE UN ENCHUFE ADAPTADOR PARA
CONECTAR EL REFRIGERADOR A UN
TOMACORRIENTE DE 2 PATAS.
NO USE UN PROLONGADOR CON ESTE
ELECTRODOMÉSTICO.

STEP 1 REMOVE PACKAGING

WARNING
Refrigerator is much heavier at the top than at the
bottom. To avoid a risk of death or serious injury,
be careful when moving, and when using a hand
truck, handle only from side.
DO NOT ATTEMPT TO ROLL UNIT OFF SKID.
AVERTISSEMENT
basculement
Parce que le haut du réfrigérateur est
plus lourd que sa base, la prudence est de mise lors son
déplacement, de l'utilisation d'un diable-brouette, de sa
manipulation faite seulement sur son côté afin d'éviter les
blessures graves ou mortelles.
IL NE FAUT PAS ESSAYER DE FAIRE ROULER
L'APPAREIL MÉNAGER POUR L'ENLEVER DE LAY
PALETTE.
ADVERTENCIA
El refrigerador es mucho más pesado en su parte
superior que en su parte inferior – tenga cuidado
al moverlo. Al usar un carro manual, sosténgalo de
costado únicamente. NO INTENTE HACER RODAR
LA UNIDAD FUERA DEL ANTIDESLIZANTE.
31-1000451 Rev. 0
Riesgo de Descarga
Tip Over Hazard.
Risque de
Riesgo de Caídas
STEP 1 REMOVE PACKAGING
(Cont.)
• Carefully cut banding at the top and bottom, remove
the outer carton.
• Slide out the back corner posts (2).
• Slide the carton off the top of the cabinet.
NOTE: IT IS NOT NECESSARY TO LAY THE
CABINET DOWN IN ORDER TO REMOVE THE SKID!
• The unit is secured
to the skid with 2 full-
length tie-down straps.
Remove the ten 5/16"
bolts from the base
channels in the tie-
downs.
• Remove the four 7/16"
bolts securing the
straps to the skid.
NOTE: DO NOT
ATTEMPT TO ROLL
UNIT OFF SKID.
• The support blocks on the bottom of the refrigeration
case must be removed before the refrigerator is taken
off the skid or damage will occur. Carefully tilt the
refrigerator and slide the blocks out from beneath.
• Remove the toekick and set aside for final installation.
• Lift the refrigerator off the skid with an appliance dolly.
Handle from the sides.
31
Remove 5 base
channel bolts on
each side
Remove 2 strap bolts
on each side

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Zips360nnss

Tabla de contenido