Monogram ZIP360NN Manual De Instrucciones página 34

Installation Instructions- Stainless Steel Installation
STEP 4 ANTI-TIP PROCEDURE
(CONT)
• Locate at least 2 studs on the back wall. Mark these
points on the horizontal line.
• Place the bottom of the wall bracket with tabs on the
horizontal line. Align the center notch on the bracket
with the center line on the wall.
Line on Wall
Center
• The anti-tip wall bracket has a series of holes. Select
2 holes that match with the located studs. Make sure
the holes selected are on the center of the studs.
Mark the wall at these points.
• Mark an additional hole at each end of the bracket.
If one of the studs is closer to the end of the bracket,
mark an additional hole towards the center of the
bracket.
Center
Two Additional
Hole Locations at
Ends of Brackets
Wall Studs
• Drill 1/2" (1.27 cm) holes into the wall board at the
locations marked for the toggles to be mounted (not
the stud markings).
• Drill 3/16" (0.47 cm) holes into wooden studs where
marked. If steel stud construction, drill 1/2" (1.27 cm)
holes into the studs where marked. You will use 2
toggles with the metal studs.
Wall Bracket
Line On Wall
STEP 4 ANTI-TIP PROCEDURE
(CONT)
Install Wall Toggles:
The wall toggles and bolts can be ordered as Service
Kit #WR49X10193. Wall toggles are installed in the
drywall and metal studs for stability. Install the wall
toggles as follows:
• Drill 1/2" (1.27 cm) holes at the wall markings made in
the holes at the ends of the wall bracket.
• Hold the metal channel flat
against the plastic straps
and slide the channel
through the hole.
• Gently pull back at the ends
of the plastic straps to make
the channel rest flush behind the wall.
• Hold the ends of the straps in
one hand and slide the plastic
cap along the straps until the
flange of the cap is flush with
the wall.
• Place your thumb between the
plastic straps and bend up and
down to snap the straps off at
the wall.
Install Screws and Bolts:
• Have someone hold the wall bracket centered in place
with each of the holes aligned with the correct opening
in the bracket and level with the horizontal line.
• Insert the lag screws through the bracket and into the
stud. Tighten with a wrench.
Lag Screw
Anti-Tip Wall Bracket
• Insert the bolts into the toggle by hand until snug.
Tighten with a wrench.
34
Plastic Straps
Metal Channel
Cap
Wood Stud
Drywall or
Steel Stud
Bolt
Wall Toggle
Anti-Tip Wall Bracket
31-1000451 Rev. 0