Step 10 Connect Power; Step 11 Start Icemaker - Monogram ZIP360NN Manual De Instrucciones

Installation Instructions- Stainless Steel Installation

STEP 10 CONNECT POWER

• Check to be sure the power cord is plugged into the
receptacle.
Electrical
Outlet
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights
are on.
• The temperature controls are preset at 37°F
for the fresh food section and 0°F for the freezer.
• Allow 24 hours to stabilize before making adjustments.

STEP 11 START ICEMAKER

CAUTION
avoid contact with the moving parts of the ejector
mechanism, or with the heating element that releases the
cubes. Do not place fingers or hands on the automatic ice
making mechanism while the appliance is plugged in.
ATTENTION
Raise
Grille
évitez tout contact avec les pièces mobiles du mécanisme
Panel
d'éjection ou l'élément chauffant qui libère les cubes. Ne
placez pas les doigts ou les mains sur le mécanisme de
production de glace automatique lorsque l'électroménager
est branché dans la prise électrique.
PRECAUCIÓN
lesiones personales, evite el contacto con las partes móviles
del mecanismo eyector o con el elemento de calefacción que
libera los cubos. No coloque los dedos ni las manos en el
mecanismo de la máquina de hielo automática mientras el
electrodoméstico se encuentre enchufado.
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the
feeler arm.
• Discard the first full bucket of
ice cubes.
• To turn the icemaker off, set
the switch to O (OFF).
NOTE: Icemaker works best
between 40 and 120 PSI (275-
827 kPa) home water pressure.
38
To minimize the risk of personal injury,
Afin de réduire le risque de blessure,
Para minimizar el riesgo de
OFF
ON
31-1000451 Rev. 0