Sears Kenmore 790.4043 Serie Manual De Uso página 15

General Care & Cleaning (cont'd)
Hinge lever hook
Hinge
support
Lock engaged for door removal
Figure 1
HINGE SLOT - Door removed
from the oven - Figure 2
Hinge lever
Lock in normal position
Figure 3
Removing and Replacing the Oven Door (Hinge A)
The door is heavy. For safe, temporary storage, lay the door
flat with the inside of the door facing down.
To Remove Oven Door:
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the
hinge lever hooks (Figure 1). You may have to apply a little downward
pressure on the door to pull the locks fully over the hinge lever hooks.
3. Grab the door by the sides and pull the bottom of the door up and
toward you to disengage the hinge supports. Keep pulling the bottom of
the door toward you while rotating the top of the door toward the range
to completely disengage the hinge levers (Figure 2).
4. To clean oven door, follow the instructions provided in the General Care
& Cleaning table.
To Replace Oven Door:
1. Grab the door by the sides; place the hinge supports in the hinge slots.
Open the door to the fully opened position.
2. Disengage the lock from the hinge lever hooks on both sides (Figure 3).
Note: Make sure the hinge supports are fully engaged before unlocking the
hinge levers.
3. Close the oven door.
15