Gas Conversion - Teka HF LUX 60 4G AL NAT Instrucciones Para La Instalación

GB_61401134_en.qxd 27.02.2015 14:52 Page 10
Gas convers�on
ImportantY
Any alterat�on that �s to be made to the
appl�ance to convert �t to a d�fferent
type of gas should only be carr�ed out
by a qual�f�ed techn�c�an.
Informat�on for Techn�cal Ass�s-
tance: whenever the type of gas or the
appl�ance's pressure �s changed, the new
regulat�on plate should be placed on top of
the old one so that the new features can
be seen after the change.
The tasks �nvolved �n convers�on are:
* Replace the �njectors.
* Adjust the taps' m�n�mums.
The �njectors requ�red for each gas type
are shown �n table 1.
To replace the �njectors, follow these �ns-
truct�ons:
1 Remove the gr�ds and upper parts of the
burner so that the �njector can be seen.
Table 1
°
2 Us�ng a number 7 p�pe spanner, remove
the �njectors and replace them w�th the
new ones. Take care to press the �njector
down f�rmly so that there �s no leakage.
3 Replace the gr�d and burners that were
prev�ously removed.
When the �njectors have been changed,
th�s �s how to adjust the m�n�mums:
1 Turn the burners on to the�r m�n�mum.
2 Pull the taps' controls f�rmly upwards to
remove them.
3 Use a sl�m, grooved screwdr�ver to turn
the screw located to the r�ght or �n the
centre of the gas tap's shaft (the flame
�ncreases when you turn to the left and
decreases when you turn to the r�ght).
4 When properly adjusted, check that the
flame does not go out when you turn the
knob qu�ckly from max�mum to m�n�-
mum.
TEKA INDUSTRIAL, S.A. assumes no
respons�b�l�ty for any hob malfunct�on �f the
gas convers�on or the adjustment of the
burners' m�n�mums has not been carr�ed
out by TEKA's off�c�al personnel.
10