Installation; Positioning The Hobs - Teka HF LUX 60 4G AL NAT Instrucciones Para La Instalación

GB_61401134_en.qxd 27.02.2015 14:52 Page 6

Installation

Important
INSTALLATION AND SETUP SHOULD
BE CARRIED OUT BY AN AUTHORISED
TECHNICIAN IN LINE WITH CURRENT
INSTALLATION STANDARDS.

Positioning the hobs

Depending on the model to be installed, an
opening with the dimensions shown in
figure 2 will be cut into the unit's worktop or
stove.
The system for fixing the hob is intended
for use with kitchen units with a thickness
of 20, 30 and 40 mm.
The minimum distance between the surfa-
ce supporting the cooking pans and the
lower part of the kitchen unit or the hood
located above the hob should be 650 mm.
If the hood's installation instructions
recommend that the gap is greater than
this, you should follow this advice.
The unit where the hob and oven will be
located will be suitably fixed.
Warnings:
When hobs are handled before
being installed, care should be taken in
case there is any protruding part or
sharp edge which could cause injury.
When installing units or applian-
ces above the hob, the hob should be
protected by a board so that the glass
cannot be damaged by accidental
blows or heavy weights.
The glues used in manufacturing
the kitchen unit and in the adhesive on
the decorative laminate of the worktop
surface should be made to tolerate tem-
peratures of up to 100ºC.
5
Minimum distances
to walls
Minimum ventilation
distances
TEKA assumes no responsibility
for any malfunction or damage caused
by faulty installation.
fig. 1