If Something Doesn't Work - Teka HF LUX 60 4G AL NAT Instrucciones Para La Instalación

GB_61401134_en.qxd 27.02.2015 14:52 Page 19

If something doesn't work

Before calling the Technical Service, please
make the following checks:
Fault
There is no spark when the
automatic ignition control is pressed
There is a spark but the burner is not igniting
Do not light the gas burners
The burner ignites but, when you stop holding down the knob
that activates the safety feature, it goes out again
The gas burners are making the pans dirty
Direction of the manufacturer : SİMECO Isı Ekipmanları ve Kalıp San. A.Ş.
19
Possible cause
There is no current
at the plug
The spark plug and the part
of the burner where the
spark should be is soiled or
greasy
Gas is not coming through
to the hob
The flame is not appearing
in the area heated by the
thermocouple
The burner openings
are dirty
The injector or
injector holder is dirty
Ege Serbest Bölgesi Akçay Cad. No:144/1 Gaziemir – İzmir
Possible solution
Check/repair the
electricity at the mains
Clean the end of the
spark plug and the
burner
Check that the gas
cylinder tap is properly
open
If it is piped gas, open
the gas tap
Clean the burner's
openings
Clean the burners'
openings
Clean the injector holder
and injector without using
anything which could
damage or alter the
diameter of the gas outlet
opening