Use And Maintenance; Elements Of A Burner; Igniting The Burners - Teka HF LUX 60 4G AL NAT Instrucciones Para La Instalación

GB_61401134_en.qxd 27.02.2015 14:52 Page 13

Use and Maintenance

Elements of a burner

Whenever you reassemble a burner,
check that all the components are pro-
perly in place, as a part that is wrongly
positioned can lead to overheating and
damage the glass.
fig. 7
Grid
Diffusing cover
Diffusing crown
Injector
Injector holder

Igniting the burners

* Make sure that the knobs are in their
correct position.
* Turn on the gas at the mains or turn the
gas cylinder's tap.
* Press down the burner control.
* Keeping the burner control pressed
down, turn it all the way till the gas igni-
tes. Keep it pressed down for between 2
13
'Burner in operation' indicator
Knob position when not in use
Maximum gas position
Minimum gas position
Off position
Star (On position)
and 5 seconds so that the safety ther-
mocouple can take effect.
* Set the control to the position required.
The ignition (ceramic and electrode)
should be cleaned regularly and care-
fully in order to avoid ignition problems.
Check, too, that the grooves in the bur-
ners have not become obstructed.
fig. 8