System Description; This Manual - Cebora WF5 Manual De Instrucciones

2

SYSTEM DESCRIPTION

2.1 Welding system composition
The CEBORA KING STAR robot welding system
is a multiprocess system developed for use in
combination with a welding robot arm on automated
welding systems.
1 Power source - remote control panel cable Art.
2065.
2 Power source - wire feeder extension Art. 2061
3 Power source - robot control cabinet cable Art.
2063
4 CAN Open Power source - robot interface or ro-
bot control cable Art. 2054.
5 Robot control cabinet.
6 Welding wire spool holder Art. 121
7 Torch.
8 Wire feeder unit Art. 1648
10 Welding wire sheath Art. 1394
21 Power source KING STAR Art. 372/374.80
22 Cooling unit Art. 1683
24 Remote power source control panel Art. 452
25 Robot interface Art. 428xx or Art. 428
26 Standard cable corresponding to the fieldbus in
use (not supplied with interface).
NOTE: If the Robot Control (Robot Control in fig. 2)
has a CANopen communication line, the interface
(25) and the cable (26) are not necessary.
The power source (21) is equipped with a dedicated
and insulated CANbus line (CAN-2) for direct con-
12
It is made up of a power source, eventually equipped
with a cooling unit, a wire feeder, a control panel and
a robot interface (Fig. 2.1).
Fig. 2
nection to the Robot Control. In this case the CAN-
open cable (4) must be requested separately .
2.2

This manual

This Instruction Manual refers to the Wire Feeder
and has been prepared to educate the personnel as-
signed to install, operate and maintain the Welding
System.
It must be stored carefully in a place familiar to users
and consulted whenever there are doubts.
It must be kept for the entire operative life-span of
the machine and used to order spare parts.
Currently the Cebora KING STAR MIG ROBOT sys-
tem has one model of Wire Feeder:
-Wire Feeder WF5, art 1648.00, for general applica-
tions
3 INSTALLATION.
The equipment must be installed by qualified per-
sonnel.
It is essential to pay especially attention to the chap-
ter on SAFETY PRECAUTIONS (par. 1).
All connections must be carried out in compliance
3301052