RIB VERTIGO Serie Manual Del Usuario página 15

INFRARED SIGNAL RECEIVER - RX
ASSEMBLY OF THE INFRARED RECEIVER
- Separate the cover with the rubber support (7) from the base (8) and remove the electronic
board (9) (Fig. 5).
- Remove the lid doing pressure with a screwdriver and insert the conduit supplied.
- Place the base (8) on the upper border of the leaf of the gate (at a maximum distance of 3
metres from the transmitter).
- Fasten it immediately using 2 self-tapping screws TCCR3,5X16 supplied (10).
- Check that the gasket is present and it is intact within the cover (7).
- If necessary, rotate the bellows assembly which includes the lens by 90°, so to direct the
infrared ray as per need (VERTIGO comes with the infrared ray set as per Fig. 5). It is possible
to direct the ray according to the needs:
- Insert the electronic board already mentioned, linked to the cover with the bellow, in the
special rails on the base.
- As power supply has been given to the receiver the DLRX red led (Fig. 4) lights on indicating
the proper functioning.
ATTENTION: In case the receiver led remains lit or blinks during gate movement, disturbs
inside the main supply are possible.
It is advisable to connect electrically to earth the terminal AD-, to shield the photocells from
these disturbs.
Be careful not to short circuit the system when the supply phases are inverted!
RECEIVER
SETTINGS AND CONNECTIONS
J3
Connector for the receiver diode
DLRX Red LED indicating correct power and
infrared signal alignment
J4 Terminal block
AD+ Power Supply 12-24V ac/dc
AD- Power Supply 12-24V ac/dc
COM Contacts' common
EDGE Normally closed contact NC
5
15
G
B
J3
DLRX
RX
J4
4
RX
6