Kit Assembly - Metra 99-7881G Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Mount the pocket to the radio brackets
with the (4) #8 x 3/8" Phillips screws
supplied. (Figure A)
2. Attach the radio brackets to the radio
trim panel with (4) #8 x 3/8" Phillips
screws supplied. (Figure B)
3. Slide the head unit into radio brackets
and secure with screws supplied with
the unit. (Figure C)
4. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
5. Use (2) supplied #8 x 1/2" Phillips
screws to secure the radio assembly in
the sub dash.
6. Reassemble dash in reverse order
of disassembly.
Note: Apply supplied clips to the factory
locations on the new radio trim panel.
99-7881G

Kit Assembly

(Figure A)
(Figure C)
(Figure B)
3