WAGNER 0538080 Manual Del Usuario página 20

Setup
Never attempt to assemble, change, or clean the gun, tip, or tip
guard without first relieving pressure from the spray system. Follow
the "Pressure Relief Procedure" in the sprayer's Owner's Manual.
Always use a tip safety guard for added protection against injection.
Beware that the guard alone will not prevent injection. Never cut
off tip guard! Always engage gun trigger lock when the gun is not
in use. Before servicing equipment, consult Owner's Manuals and
follow all warnings.
1. Set up the sprayer. Refer to the instructions
in the sprayer's Owner's Manual.
2. Attach a grounded, airless spray hose to
the material inlet on the gun. Using two
wrenches (one on the gun and one on the
hose), tighten securely.
3. With the tip and tip guard off the gun, start
the sprayer. Flush and prepare the spray
system according to the sprayer's Owner's
Manual. Inspect the spray system to make
sure that all fittings are secure and that there
are no leaks.
4. Perform the "Pressure Relief Procedure" described in the sprayer's Owner's
Manual.
5. Using the end of the spray tip (5), insert the tip seal (3) and seal (4) into the
back of the tip guard (2). Press in for final adjustment.
6. Insert the tip (1) into the slot on the tip guard.
7. Thread the tip guard onto the gun. Position the tip guard in the desired
spraying position, then tighten securely.
The arrow on the tip handle should be pointing in the forward
i
direction for spraying.
20
5
1
2
4
3