Descargar Imprimir esta página

bort medical 100 900 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
EN
Step 3
[ 4 ]
Place your leg in the pre-set and adapted BORT ROM knee brace, adaptions/re-adjustments must be
made by expert staff.
Ensure correct positioning and even surface contact. The joints should be positioned on the side of the
knee joint at the height of the centre of the patella (middle of the kneecap).
Step 4
[ 4 ]
Firstly, close the wide fastener beneath the knee joint in order to fix the brace on the leg.
Step 5
[ 5 ]
Close the fasteners in the following order, always starting from the centre of the knee:
1. Fastener close to the knee on the lower leg (#1)
2. Fastener close to the knee on the thigh (#2)
3. Fastener away from the knee on the lower leg (#3)
4. Fastener away from the knee on the thigh (#4)
Whilst tightening the fastener, smoothen it in the tension direction with your free hand. This avoids twisting
the brace on the leg.
Information: should you incur pressure sores, pain or other problems whilst wearing the brace, remove it
and contact your technician
Allow yourself time to become accustomed to the brace and increase the wearing time gradually.
If you have questions regarding the use and wearing time, please refer to your physician or technician.
Removal
To remove the aid, open the harnesses and then take the brace off the leg. Close all the Velcro fasteners in
order to avoid damaging other items, e.g. to further clothing.
Information for the technician
Important note: The brace may only be adapted by expert staff.
Adaption of the BORT ROM knee brace on the patient
Step 1
[ 1 ]
[ 2 ]
,
Open all the brace's fasteners. This can either be done by opening the blue quick action
fasteners or by unlooping the harnesses. The strap length can be set shortening the straps. For this, the
crocodile fasteners can be removed at the respective end of the strap. After successful setting of the
fastener lengths, they can be fixed using Velcro tape.
Step 2
[ 3 ]
The patient should sit down and slip forwards to the edge of the chair, the knee joint is bent slightly.
10

Publicidad

loading