Securing The Cart Back Panel; Installing The Bottom Shelf; Mounting The Front Support Legs - Pit Boss CHARLESTON PB1230CC Instrucciones Y Recetas

6. SECURING THE CART BACK PANEL

Parts Required:
1 x Cart Back Panel (#34)
4 x Screw (#D)
2 x Screw (#K)
Installation:
• Mount the Cart Back Panel to each Back Support Leg using two screws
(D) in each Support Leg. Ensure the flat surface of the Back Cart Panel
is facing outwards.
• Next, secure the Cart Back Panel to the Main Barrel using two screws
(K). Install screws from the inside of the Main Barrel through the pre-
drilled holes.

7. INSTALLING THE BOTTOM SHELF

Parts Required:
1 x Bottom Shelf (#36)
2 x Screw (#A)
2 x Locking Washer (#C)
2 x Washer (#B)
Installation:
• Place the Bottom Shelf in a vertical position between the two Back
Support Legs. With the flat surface facing up towards the Main Barrel,
secure the Bottom Shelf to each Back Support Leg by using two screws,
locking washers, and washers.
NOTE: Ensure the curved indent on one side the Bottom Shelf is
positioned on the right side of the cart. It's for the gas cylinder.

8. MOUNTING THE FRONT SUPPORT LEGS

Parts Required:
1 x Left Support Leg - Front (#27)
1 x Right Support Leg - Front (#29)
6 x Screw (#A)
6 x Locking Washer (#C)
6 x Washer (#B)
Installation:
• Mount the Front-Left Support Leg to the Main Barrel using three
screws, locking washers, and washers. Install the Support Leg from the
inside of the Main Barrel through the pre-drilled holes.
• Mount the Front-Right Support Leg to the Main Barrel using three
screws, locking washers, and washers. Install the Support Leg from the
inside of the Main Barrel through the pre-drilled holes.
12
6
34
D
D
INSIDE VIEW
K K
7
36
8
27
29
INSIDE VIEW