Mounting The Legs To Main Barrel; Installing The Bottom Shelf; Securing The Cart Front/Back Panels - Pit Boss Pro PB1100PSC2 Manual Del Usuario

3. MOUNTING THE LEGS TO MAIN BARREL

Parts Required:
1 x Support Leg /Front (#30)
1 x Support Leg /Back (#31)
1 x Support Leg for Caster /Front (#32)
1 x Support Leg for Caster /Back (#33)
12 x Screw (#A)
12 x Locking Washer (#C)
12 x Washer (#B)
Installation:
• Mount one Support Leg to the floor end of the Main Barrel using
three screws, locking washers, and washers, through the three pre-
drilled holes. Install screws from the inside of the Main Barrel. Repeat
installation for second Support Leg.
• Mount one Support Leg for Caster to the hopper end of the Main Barrel
using three screws, locking washers, and washers, through the three
pre-drilled holes. Install screws from the inside of the Main Barrel.
Repeat installation for second Support Leg for Caster.
NOTE: Fasten screws of the support legs only half-way to allow
easier installation of bottom shelf in next step.

4. INSTALLING THE BOTTOM SHELF

Parts Required:
1 x Cart Bottom Shelf (#39)
4 x Screw (#A)
4 x Locking Washer (#C)
4 x Washer (#B)
Installation:
• Attach the Cart Bottom Shelf using a washer, locking washer, and
screw on each of the Support Legs by hand, but fasten only half-way.
NOTE: The side of the Cart Bottom Shelf with two holes should be
assembled on the gas side.
5. SECURING CART FRONT/BACK PANELS
Parts Required:
2 x Cart Front / Back Panel (#36)
12 x Screw (#A)
12 x Locking Washer (#C)
12 x Washer (#B)
Installation:
• Secure the Cart Front Panel to each leg using two washers, locking
washers, and screws on each of the two support legs. Secure the
Cart Front Panel to Main Barrel using another two washers, locking
washers, and screws. Repeat installation for the Cart Back Panel.
NOTE: Once the Cart Panels are installed, then tighten secure all of
the Cart screws.
3
33
32
31
30
4
39
B
C
A
5
36
36
A C B
11