Turning Off - Peltor WS Alert Manual De Instrucciones

Quick guide for synchronising (pairing) the WS Alert headset
Bluetooth unit with a mobile telephone
1. Turn all WS Alert headset functions OFF. (If necessary,
remove and re-install batteries.)
2. Press and hold the Bluetooth button on the left cup for 8
seconds.
3. Search for the new Bluetooth unit, Peltor WS3, according to
your telephone's directions for use.
4. Press and hold the Bluetooth button for 8 seconds until the
LED glows red.
Activation
5. Activate the Bluetooth function by pressing and holding the
Bluetooth button on the left cup for 2 seconds.
6. Activate the radio or the surround sound function on the right
cup.

Turning off

7. Turn off any of the three functions separately.
Usage time, WS Alert headset
Mode
All functions turned off
Bluetooth only, standby
Bluetooth only, active
Surround+bluetooth, standby
Radio+bluetooth, standby
Surround+radio+Bluetooth, standby
Surround+bluetooth, active
Radio+bluetooth, active
Surround+radio+Bluetooth, active
All calculations are based on a
2400 mAH battery
operating
time
hours
(average)
-
342
43
133
48
41
35
24
23

Current
consumption
mA
(average)
0
7
55
18
50
58
67
100
102