Peltor WS Alert Manual De Instrucciones página 4

EN
Change to instructions for the Bluetooth
function in this Peltor WS Alert Headset
1. Pairing with another Bluetooth unit
To establish a wireless communication link between two Bluetooth units, you must pair them
up. This only needs to be done once per pair of units. Start with the headset switched off.
► Press and hold the Bluetooth button for at least 8 seconds to prepare the headset for the
first pairing with another Bluetooth unit.
First the LED glows green and four ascending tones are emitted in the headset. Then the
LED blinks five times briefly and then shines steadily green again, and a brief tone is emitted
every three seconds. Now you can pair the headset with the other unit. You must do so
within three minutes.
A successful pairing is confirmed with 8 brief blinks of the green LED and 3 brief audio
signals in the headset. Now the units can communicate by Bluetooth.
If the pairing fails, the LED glows red for one second and an audio signal of descending
tones is emitted in the headset.
If the pairing fails, or if the Bluetooth button is pressed again during synchronisation, the
headset automatically switches off.
The headset can store pairing data for eight Bluetooth units, which you switch between by
deactivating the link to one unit and activating the link to another.
Example: Disconnect an adapter and then connect a phone by pairing through the phone
menu. You can reconnect the adapter by using the phone's menu to disconnect, then
reconnecting the adapter. If there are many Bluetooth users nearby, you may need to repeat
the connection to re-establish the link. Try again!
When pairing with a Bluetooth phone, you can usually see on the phone's display what unit
or units are linked to it and in range.
A Peltor WS Alert headset appears as Peltor WS3 in the phone display. Some phone models
require a PIN for the phone to identify the headset; if so, the code is four zeroes (0000). This
applies to all Peltor WS Headsets and cannot be changed by the user.
Disconnecting the Bluetooth link after pairing
► Press and hold the Bluetooth button for at least 8 seconds. The LED glows red for one
second and you hear four descending tones in the headset. Then the unit is disconnected.
2. Switching the Bluetooth function on and off
Switch the Bluetooth function on by pressing and holding the Bluetooth button on the left
cup for 2 seconds. You hear four ascending tones and the LED on the headset blinking
green every 5 seconds.
The Bluetooth function switches off automatically  hours after Bluetooth communication
ceases.
If you use the WS Alert as a simple headset (with no radio or ambient noise), you need only
connect the Bluetooth function.
► Press and hold the Bluetooth button for more than two seconds.
Release the button after hearing the four ascending tones that confirm that the headset is
switched on. Shortly thereafter, you hear two ascending tones indicating that the Bluetooth
link is connected. The LED glows green until you release the button, then it blinks green
every 5 seconds. (Note: If you press and hold the button for 8 seconds, the headset is ready
to be paired with another Bluetooth unit. See point 1 above!)
Disconnecting the Bluetooth link after using the unit as a headset.
► Press and hold the Bluetooth button for at least 8 seconds.
Ignore the tone you hear after 2 seconds and do not release the button until you hear 4
descending tones, when the LED blinks red once and the headset is disconnected.
The headset does not switch off if the Bluetooth button is used as a PTT button with a Peltor
WS adapter, but if the Bluetooth link is not active it switches off automatically after 2 hours.