Exploded View - Look 585 Manual Del Usuario

GB
Congratulations !
Thank you for choosing a LOOK frame and
fork assembly.
We would like to thank you for your
confidence in our products.
This LOOK frame and fork assembly is a very
technical French designed product.
Your LOOK 595 frame and HSC fork are
identical to those supplied to major
professional teams and are inspected
throughout their manufacturing process so
that you will be ensured full satisfaction
with them.
All LOOK products comply with both
European and International standards.
We recommend that a professional
performs the installation and assembly
of your bicycle and its accessories.
It is important to read all instructions
before starting, and respect all recom-
mendations given to achieve full benefit
of this high quality product.
LOOK reserves the right to change
product specifications without prior
notice in order to improve it.
16
Your frame:
Your frame was manufactured in accor-
dance with the specifications determined by
the LOOK design headquarters.
Your frame includes the seatpost clamp, bot-
tom bracket cable guide, replaceable rear
derailleur hanger, water bottle bolts, front
derailleur braze on tab (on the "486" ver-
sion), and front brake attachment nut.
This built-in steering assembly frame is sup-
plied with the Aheadset carbon pivot fork,
the corresponding steering assembly, and
thickness rings and the steering assembly
adjustment cap.
The steering assembly is delivered com-
pletely assembled and greased.
WARNING:
This LOOK Frame is construction and
optimized to be used by cyclists less than
100 kgs (220.5 lbs)
INSTALLING THE 1-1/8" LOOK INTEGRATED STEERING ASSEMBLY
Specific feature of the steering assembly
and the frame:
The frame's head tube internal bearing
assembly contains two removable inner
and outer bearing thrust rings, patented
by LOOK. These rings are installed at
the factory but may be replaced if they
are damaged... This system provides
added protection to the frame's head tube
assembly.
Check before installation:
Pre-assemble the components in the upper
bushing in the order shown on the diagram.
Pre-assemble the components in the lower
bushing. Check that there is sufficient
clearance between the bushing and the fork
so that the fork can turn freely.
The bearings must be assembled in the
bushing with little or no resistance.
GB
EXPLODED VIEW
Upstand
Ring
1-1/8" bearing
Bearing thrust
ring
UPPER PART
STEERING BUSHING
LOWER PART
Bearing thrust
ring
1-1/8" bearing
17