KTM 60314910033 Manual Del Usuario página 12

A
12
11
5
4
1
1
33
B
3
9
7
29
C
- Using a cone drill, drill a hole at position A or B into the cockpit trim (33)
(Ø24 mm).
When drilling, ensure that you do not damage any components.
- Mount the 12-V socket.
- Insert the switch (3) and secure it with the nut of the switch.
NOTE:
When the fog lights are switched on, the switch lights up green.
- Route the switch cable inward to the headlight.
- Mount the inside trim (29), grille (27), and air inlet (26).
- Mount the headlight holder (4) on both sides with screws M5x25 (5) and
bushings (11).
- Mount and tighten the fog lights (1) on both sides with Nord-Lock wash-
ers (9) and screws M6x45 (7).
- Drill a Ø22-mm hole at position C in the left and right inside trim (29).
- Connect the fog light (1) and pass the cable through the hole.
- Position the cable sleeve in the hole.