Circuit Diagram - KTM 60314910033 Manual Del Usuario

14

Circuit diagram

33
To set the fog light range:
- Park the vehicle on a level surface in front of a light-colored wall and make
a mark on the wall at the height of the fog lights.
- Make another mark a distance of B=5 cm below the first mark.
- Park the vehicle a distance of A=5 m away from the wall and perpendic-
ular to it, and switch on the fog lights.
- The rider now sits down on the motorcycle, with baggage and a passenger
if applicable.
- The light-dark boundary must lie exactly on the lower marking for a motor-
cycle that is ready to use with the rider and any baggage and a passenger.
- Correct the fog light range if necessary.
NOTE:
The fog lights must not have a greater range than the low beam.
33
- ACC1 is continuous plus and protected with a 10-A fuse.
- ACC2 is connected to the ignition and is protected with a 1-A fuse.