Sime Brava Slim HE 25 T Manual De Instalación Y Mantenimiento página 65

EN
pressing any one of these buttons for more than 30 sec-
NB:
onds generates a fault on the display without preventing boil-
er operation.The warning disappears when normal conditions
are restored.
DISPLAY
1
l
. This symbol appears when the boiler is
"SUMMER"
operating in "Summer" mode or if only the domestic
hot water mode is enabled via the remote control. If the
symbols l and n
the chimney sweep function is active.
n
"WINTER" . This symbol appears when the boiler is
operating in "Winter" mode or if both the domestic hot
water and heating modes are enabled via the remote
control. With the remote control, if no operating modes
have been enabled both symbols
off.
d
"RESET REQUIRED" . The message indicates that after
having repaired the fault, normal boiler operation can
be restored by pressing the button
r
"DOMESTIC HOT WATER"
a DHW request or during the "chimney sweep fun-
ction" It flashes during the selection of the domestic
hot water set point.
t
. This symbol lights up during heating ope-
"HEATING"
ration or during the "chimney sweep function It flashes
during the selection of the heating set point.
f
"BLOCK" DUE TO NO FLAME
F
.
"FLAME PRESENCE"
v
"POWER LEVEL" . This indicates the power level at which
the boiler is operating.
p
"PARAMETER" . This indicates that the user may be in
parameter setting/display, or "info" or "counter", or in
"activated alarms" (history).
A
"ALARM" . This indicates that a fault has occurred.
The number specifies the cause which generated the
alarm.
z
. This indicates that the "chimney
"CHIMNEY SWEEP"
sweep function" has been activated.
e
"EXTERNAL SENSOR" . This indicates that the external
sensor has been installed and that the boiler is wor-
king on a sliding temperature.
are flashing, this indicates that
l and n will be
y .
. This symbol is present during
.
65