2.13.2 Chrono-Thermostat Or Air Thermostat; Example Of Use Of The Command/Control Device On Some Types Of Heating Systems - Sime Brava Slim HE 25 T Manual De Instalación Y Mantenimiento

2.13.2 Chrono-thermostat or Air Thermostat

The electrical connection of the chrono-thermostat or air
thermostat has already been described. When fitting the com-
ponent in the room where the readings are to be taken, follow
the instructions provided on the packaging of the product it-
self.
2.13.3 EXAMPLE of use of the command/control
device on some types of heating systems
KEY
M System delivery
R System return
Mb Hot water tank delivery
Rb Hot water tank return
CR Remote control
EXP Expansion card
SE External sensor
SB Hot water tank sensor
TA÷TA3 Air thermostat for the zone
VZ1-VZ3 Zone valves
RL1-RL3 Zone relays
P1-P3 Zone pump
SI Hydraulic separator
ONE DIRECT ZONE system and REMOTE HOT WATER TANK,
external sensor and air thermostat or, alternatively, remote
control.
SE
M
CR TA
Mb Rb
m
CAUTION
The boiler is pre-arranged for connection to a re-
mote hot water tank. To use the boiler for HEATING
ONLY:
– disconnect the hot water tank sensor (SB)
– set "PAR 02 = HYDRAULIC CONFIGURATION" to 1.
This operation must only be carried out by Profes-
sionally Qualified Personnel during the boiler com-
missioning phase.
74
R
SB
Fig. 23
ONE DIRECT ZONE system , external sensor and air thermo-
stat or, alternatively, remote control.
SE
M
R
CR TA
MULTI ZONE system -with pump, air thermostat and exter-
nal sensor.
TA1
TA
RL1
SE M R
P1
SI
MULTI ZONE system -with zone valve, air thermostat and ex-
ternal sensor.
TA
TA1
SE M
R
VZ1
m
CAUTION
Set the parameter "tS 17 = DELAY SYSTEM PUMP
ACTIVATION to allow the opening of zone valve Vz.
EN
Fig. 24
TA3
TA2
RL2 RL3
P2 P3
Fig. 25
TA2 TA3
VZ2 VZ3
Fig. 26