Keypad Operation; Digital Operator Display (Optional) - Omron VARISPEED F7 Guía De Referencia Rápida

Keypad Operation

Digital Operator Display (optional)

The key names and functions of the Digital Operator are described below
Digital Operator Keys
Key
EN-14
Name
Switches between operation via the Digital Operator (LOCAL) and
LOCAL/REMOTE Key
the settings in b1-01 and b1-02 (REMOTE).
This key can be enabled or disabled by setting parameter o2-01.
MENU Key Selects the modes.
ESC Key Returns to the status before the DATA/ENTER Key was pressed.
Enables jog operation when the Inverter is being operated from the
JOG Key
Digital Operator.
Selects the rotation direction of the motor when the Inverter is being
FWD/REV Key
operated from the Digital Operator.
Sets the active digit when programming user parameters.
Shift/RESET Key
Also acts as the Reset key when a fault has occurred.
Selects user parameter numbers and increments parameter set-
Increment Key
tings.
Used to move to the next item or data.
Selects user parameter numbers and decrements parameter set-
Decrement Key
tings.
Used to move to the previous item or data.
DATA/ENTER Key Enters menus and parameters and validates parameter settings.
Starts operation when the Inverter is being controlled by the Digital
RUN Key
Operator (LOCAL Mode).
Stops Inverter operation (LOCAL and REMOTE Mode).
STOP Key
This key can be enabled or disabled when operating from a source
different tan the operator by setting parameter o2-02.
Drive Mode Indicators
FWD: Lights up when a forward run command is
input.
REV: Lights up when a reverse run command is
input.
SEQ: Lights up when any other run command
source than the Digital Operator is selected.
REF: Lights up when any other frequency reference
source than the Digital Operator is selected.
ALARM: Lights up when an error or alarm has
occurred.
Data Display
Displays monitor data, parameter numbers, and set-
tings.
Mode Display (displayed at the upper left of the data display
DRIVE: Lights up in Drive Mode.
QUICK: Lights up in Quick Programming Mode.
ADV: Lights up in Advanced Programming Mode.
VERIFY: Lights up in Verify Mode.
A. TUNE: Lights up in Autotuning Mode.
Keys
Execute operations such as setting user parameters,
monitoring, jogging, and autotuning.
Function